Hardware Specifications
- Input Channels
The system comes standard with simultaneously sampled 24-bit
input A/D's with 130dB dynamic range. The input impedance is 100k ohms.
Accelerometer constant current source and TEDS are standard on all channels.
1 to 32 channels, configured in blocks of 4.
- Output Channels
The system comes standard with two 24-bit output D/A's with < -100db THD+N. Outputs are 10 ohms impedance with a range
of 20-volts peak-to-peak.
- Noise Floor
The system has an extremely low noise floor of <70nV/√Hz
- Redundant Calibration Monitoring
The system uses an extreamly stable voltage source to monitor
the calibration values and will display warnings before the system goes out of calibration
- Built in Self Diagnostics
The system monitors its internal state and will display warnings when there are problems
- Sample Rates
The system has 241 sample rates that range from 100hz to 108,000 Hz
- Ethernet Interface
The system communicates to the PC using a standard Ethernet port. This eliminates
the need for special cables and cards. This also gives much more flexibility
in the location of the controller.
- 24-bit Accuracy
The 24 bit A/D and D/A converters on the 9500 gives it the ability to resolve signals 130dB apart.
- TEDS Interface
The 9500 supports the IEEE standard for Transducer Electronic Data Sheet accelerometers.
- High Frequency (Optional)
Allows control past 4900 Hz to 32,000 Hz.
|
